Apply a thin layer of CRYSTAL CLAWZ Base Coat, covering the entire nail.
Cure under LED lamp for 30 seconds (approx. 2 minutes under a UV lamp).
Squeeze the tube of Velocity Speed Gel to release a little of the gel and slice off the desired amount with the metal applicator on the Dual Brush. NOTE – you need less than you think you do, so slice off a small amount at a time.
Place the Velocity Gel on the nail plate near the cuticle.
Switch to the brush side of the Dual Brush.
Dip the brush into the Slip Solution, then shape the nail by lightly patting the Velocity Speed Gel to spread it over the nail (and form, if sculpting) until it is completely covered
Cure under LED lamp for 60 seconds (approx. 3 minutes under a UV lamp).
Wipe with sanitiser to remove inhibition (tacky/sticky) layer.
File to desired length and shape; ensuring that the end product is smooth and thin, without any bumps.
Use Buffer block and buff to smooth the surface.
Remove all dust using your dusting brush.
Wipe nail using a lint free cotton wipe and sanitiser.
Apply top coat.
REVERSE MOULD APPLICATION
STEP-BY-STEP
Prepare and sanitise the nail
Apply a thin layer of CRYSTAL CLAWZ Base Coat, covering the entire nail.
Cure under LED lamp for 30 seconds (approx. 2 minutes under a UV lamp).
Squeeze the tube of Velocity Speed Gel to release a little of the gel and slice off the desired amount with the metal applicator on the Dual Brush.
Place the Velocity Gel on the inside of the moulding tip.
Switch to the brush side of the Dual Brush.
Dip the brush into the Slip Solution, then spread the Gel evenly on the inside of the nail form until it is completely covered. Application should be THINNER at the cuticle and side wall area to prevent product flooding when placing on the nail.
Press the filled form gently onto the nail. VERY IMPORTANT – the gel MUST NOT ooze from under the tip. If this happens, you may not be able to remove the moulding tip once the gel is cured. Check around the cuticle and side wall area and remove any excess gel that may have squeezed out from under the moulding tip.
Cure under LED lamp for 60 seconds (approx. 3 minutes under a UV lamp).
Remove the moulding tip by gently squeezing and lightly twisting at the free edge to pop the tip loose.
Wipe with sanitiser to remove inhibition (tacky/sticky) layer.
File to desired length and shape; ensuring that the end product is smooth and thin, without any bumps.
Use Buffer block and buff to smooth the surface.
Remove all dust using your dusting brush.
Wipe nail using a lint free cotton wipe and sanitiser.
